What coding environments can I use with Vernier sensors?
Since we started this company in the early 1980’s, we have always tried to provide a way for teachers and students to “do their own thing”, using our sensors. The following provides a list of coding...
View ArticleCan I use a Vernier Ion-Selective Electrode (ISE) with Arduino?
Yes, it is possible to use a Vernier Ion-Selective Electrode (ISE) with an Arduino microcontroller. However, we do not recommend this combination unless you are familiar with the sensor’s user manual...
View ArticleClik here to view.
CBR 2 Troubleshooting and FAQs
CBR 2 (CBR2) Specifications and User Guide Which Motion Detector model do I have? Troubleshooting Primary test: When you start data collection, do you hear a clicking from the CBR 2? If not, the...
View ArticleClik here to view.
Go Direct Tris-Compatible Flat pH sensor stays at pH 6.8-7 after a custom...
Some Go Direct® Tris-Compatible Flat pH (GDX-FPH) were shipped with firmware that can cause the sensor to read a fixed pH of ~6.8 after a custom calibration. This issue can be observed in Graphical...
View ArticleClik here to view.
Which Go Direct Acceleration do I have? Does it support Remote Data Logging?
The following are the different versions of the Go Direct® Acceleration Sensor (GDX-ACC) that we have sold. Only the most recent version, released in April 2025, supports Remote Data Logging. Because...
View ArticleClik here to view.
Dynamics Cart & Track System with Go Direct Sensor Carts Troubleshooting and...
Dynamics Cart & Track System with Go Direct Sensor Carts DTS-GDX—1.2 m trackDTS-GDX-LONG—2.2 m track Specifications and User Guide Go Direct Sensor Cart Information Troubleshooting Primary Test:...
View ArticleWhat minimum version of software is required for the Lateral Force Accessory?
The Lateral Force Accessory (2D-FP) is an accessory to the Go Direct® Force Plate (GDX-FP) and the Force Plate (FP-BTA). The minimum software releases are as follows: Graphical Analysis version 6.1...
View ArticleWhat happens when I connect an analog sensor to the port on my Go Direct...
The “BTA” analog port on the Go Direct® Force Plate (GDX-FP) is designed for the Lateral Force Accessory (2D-FP). When this accessory is connected to the port, you can activate the Lateral Force...
View ArticleClik here to view.
How do I set up my Ladder Experiment Kit?
The Ladder Experiment Kit (2DFP-LAD) is designed to be used with the Go Direct® 2-Axis Force Plate (GDX-FP2D) or 2-Axis Force Plate (FP2D-BTA) to investigate reaction forces at work on a ladder. It is...
View ArticleGo Direct Turbidity Troubleshooting and FAQs
Go Direct® Turbidity (GDX-TRB)Specifications and User Guide Troubleshooting Primary Test: place a cuvette of distilled water in the sensor. It should read zero. If it reads anything else, check your...
View Article